DIY

3D Pen on speed

3D Pen

3D Pen

Our community member Daniel is hacking a nice 3D Pen for professional 3D artists. Instead of putting everything in the pen itself and only have low power throughput he uses a Prusa control board and a Bowden cable to have a powerful stepper motor in the back and only the hotend with very tiny fans in hand. By doing so the output is much more consistent and the throughput is much higher compared to a normal 3D pen. The Prusa control is reconfigured to have a constant hotend heating and by pressing a single button on the pen itself starts the “printing”.

turboadmin2000

Author turboadmin2000

More posts by turboadmin2000
Translate